New Rear End Yoke Shaft Protection Sleeve. Fits John Deere Skidder Model(s): 340D | 440 | 440A | 440B | 440C | 440D | 540 | 540A | 540B | 540D | 540G-II | 540G-III | 640 | 640D | 640G-II | 640G-III | 740.
Installation Instructions:
1- Clean Shaft & Remove Burrs
2- Put sleeve on top of shaft
3- Check to ensure there will be no clearance issues with flange
4- Using a cutting tool, cut flange along precut groove on sleeve flange (should be done PRIOR to installation)
5- Eliminate any burrs
6- Put the assembly tool over sleeve
7- Apply uniform pressure to the assembly tool to push sleeve into place until the worn area is covered by the sleeve
8- Lubricate sleeve
9- Continue with seal installation
Your John Deere Power Winch is a important to your logging operation, and the key to its great performance is a well-adjusted brake band. Don’t worry, maintaining a properly adjusted brake band is easy – just follow the steps below and you’ll have your winch band installed with confidence.
Troubleshooting a John Deere winch can be a daunting task, especially if you are not familiar with the inner workings of the machine. However, with some basic knowledge and the right tools, you can easily troubleshoot and fix any issues with your winch. In this article, we will discuss common problems with John Deere winches and provide you with troubleshooting tips to help you get your winch up and running smoothly.
J-K Equipment is a family-owned business established in 2008. Owner Kevin Mason had over 26 years of experience working in the John Deere shop before starting J K Equipment. We have an extensive selection of parts and offer assistance in finding the parts you need.
